Sanyo FXD-780RDS Operating Instructions Manual page 9

ADJUSTING THE SOUND STAGE .............................4
You can adjust the position of sound stage to best serve a particular seat.
TO MEMORY THE SOUND STAGE ................................................... 4
1.
Adjust the BALANCE & FADER.
2.
Press the appropriate Preset buttons 4 for more than 2 seconds. The balance & fader indicator blinks
and adjusted sound stage is stored.
TO CALL THE SOUND STAGE ......................................................... 4
Press the appropriate Preset buttons 4 to call the desired sound stage during the BALANCE & FADER
adjustment mode. The Preset buttons are factory-set to the following conditions.
P 1 : For the left seat
1
P 2 : For the front seat
2
P 3 : For the right seat
3
P 4 : For the rear seat
4/SHF
P 5 : For all the seat
5/RPT
Each time you press the Preset buttons 4 in the BALANCE & FADER adjustment mode, the audio position
indicator changes as follows ;
1 2 3
TEL MUTE FUNCTION
Shut down the audio system temporarily whenever an incoming call is received.
When the telephone rings:
When a call is received, "TEL–MUTE" is displayed and all the unit functions are temporarily interrupted.
Turning TEL Mute Function Off After Phone Call:
Hang the phone up.
"TEL–MUTE" disappears from the display window. The original source (i.e., the one used before the phone
call) is returned to automatically, and the volume restored.
Note
The function will not work if a cable is not connected to the car phone.
IGNITION-OFF CLOCK RECALL .............................3
Press the AUDIO button 3 while the ignition switch is in the "OFF" position.
The display will illuminate showing the time and then automatically shut off after 5 seconds.
BALANCE
( L0 R2 )
( L0 R0 )
( L2 R0 )
( L0 R0 )
( L0 R0 )
4/SHF 5/RPT
FADER
( R4 F0 )
( R4 F0 )
( R4 F0 )
( R0 F4 )
( R0 F0 )
GB–8