Switching The Display; Adjusting The Sound Characteristics - Sanyo Fxd-780Rds Operating Instructions Manual

SWITCHING THE DISPLAY ........................................3

Each time you press the AUDIO button 3, the item changes as follows ;
Initial set
↓
PS ➔ Frequency ➔ PTY ➔ Clock ➔ BAS ➔ TRE ➔ LOUD ➔ BAL ➔ FAD ➔ Mute level ➔ LO/DX
DISPLAY PRIORITY SELECTOR ...................................................... 3
You can adjust with which priority items are to be displayed. Display priority can be set for the following
four items ;
• PS (Programme Service name)
• Frequency
Press the AUDIO button 3 until your requested item being displayed, then hold the AUDIO button 3 pressed
for more than 2 seconds (Beep tone will be heard) to set priority to the item.
ADJUSTING THE SOUND
CHARACTERISTICS .............................................2, 3
1.
Each time you press the AUDIO button 3 until the desired mode is displayed.
2.
Rotate the VOL dial 2 to adjust the selected item. Make the adjustment within 5 seconds after selecting.
After 5 seconds, the display window will revert to display priority.
• MUTE LEVEL controls the volume level used when the sound is muted. You can adjust the level by
the volume is reduced from the previous volume level.
BASS (BAS 0)
TREBLE (TRE 0)
LOUDNESS (LOUD OFF)
BALANCE (L 0:R 0)
FADER (R 0:F 0)
MUTE LEVEL (MUTE –20)
Local/DX(SENS DX)
LOUDNESS EFFECT
When listening to music at low volume levels, this feature will boost the extremes of the bass and treble
ranges to compensate for the negative characteristics of human hearing.
LOCAL/DISTANT(LO/DX) SELECTION
This feature is used to select the strength of the signals at which the radio will stop during Automatic
Tuning. Select the Local (LO) setting and only the strongest (local) stations will be received. The "LOC"
indicator appears in the display window.
Select the Distant setting and the radio will stop at a wider range of signals, including weaker more distant
stations. The "LOC" indicator will go out on the display window.
• PTY (Programme Type)
• Clock
Adjustment Range
BAS –5
TRE –5
LOUD ON
BAL L9 R0 (Full left)
FAD R0 F9 (Full front)
MUTE – 0
SENS DX
GB–6
BAS +5
TRE +5
LOUD OFF
BAL L0 R9 (Full right)
FAD R9 F0 (Full rear)
MUTE –80
SENS LO