Numbering (Except Ptb Seq); Inputs Status; Lcd Contrast; Lcd Backlight - TAG Heuer Chronoprinter 540 User Manual

5.2.3.

Numbering (except PTB SEQ)

Manual or Automatic competitor numbering assigned to any of the 4 inputs.
Automatic: in ascending UP order or in reference to a previous run ranking order (or BIBO)
Manual: enter the competitor's N° +
5.2.4.

Inputs Status

Selection of Inputs and their timing info functions info (transmit / received)
Three statuses
The default status of the input is as follows (after switching off the CP540)
E1
The inputs are reported as « Transmit »
Example :
CP540 (A) records Starting Time
CP540 (B) records Finish Time
Download the Start time from CP540 (A) into the CP540 (B) for the net time calculation and
from CP540 (B) into the CP540 (A).
Configure the Input as follows
E1
The input's status should be specifically programmed when several CP540's need to
communicate together via RS 232 or with GSM Docking station.
Thus, each Chronoprinter will be able to receive recorded information at the Start and Finish
point.
5.2.5.

LCD Contrast

LCD screen Backlight adjustment with
default setting)
5.2.6.

LCD Backlight

Adjusts the brightness of LCD Backlight.
100% is the default setting (with an external power supply connected)
30% is the default setting (when running only on internal batteries)
It is recommended to set the value at 0% during daylight conditions to guarantee the best
internal battery life.
5.2.7.

LCD Delay

LCD duration of the currently displayed information. Adjust with
then validate
TAG Heuer Timing
Transmit
Close
Received
E2 E3
CP540 (A) – Start
E2 E3 E4
◄┘
(5 seconds is the default setting)
(E1 – E4) normally before a timing impulse is received.
E4
CP540 (B) – Finish
E1 E2
▲ ▼
plus / less, and validate with
E3 E4
◄┘
(30% is the
▲ ▼
Plus / Less,
Page 13 / 44