Firmware Jumping - V.cj - TAG Heuer Chronoprinter 540 User Manual

22. Firmware JUMPING – V.CJ
New Timing Mode :
- Jumping
With Start Count Down (Input 3), Start Phase 1 (Input 1), Finish Phase 1 (Input 4)
- Jumping – Jump-off
With Start Count Down (Input 3), Start Phase 1 (Input 1), Jump-Off (Input 2), Finish Phase 2 (Input 4)
These two modes allow you to time in Stand-Alone a Jumping Race (with or without Jump-Off) directly with our
Chronoprinter 540.
With these modes, you will be able to add and remove Penalties, Stop/Restart, automatically calculate points
penalties, time limit penalties (phase 1 or 2) and also automatically add Pause Penalties when they are
required.
Input Configuration
Input 1: Start Jumping Timing
Input 2: Jump-off (available only with mode "Jumping – Jump-Off")
Input 3: Start Count down, Pause
Input 4: Finish
TAG Heuer Timing Page 43 / 44