Table of Contents
Advertisement
5.8.3.
Numbering (except PTB SEQ)
Manual or Automatic competitor numbering assigned to any of the 4 inputs.
Automatic: in ascending UP order or in reference to a previous run ranking order (or BIBO)
Manual: enter the competitor's N° +
5.8.4.
Inputs Status
Selection of Inputs and their timing info functions into (transmit / received) for each Input
Three statuses
The default status of the input is as follows (after switching off the CP 545)
E1
The inputs are reported as « Transmit »
Example:
CP 545 (A) records Starting Time
CP 545 (B) records Finish Time
Download the Start time from CP 545 (A) into the CP 545 (B) for the net time calculation and from
CP 545 (B) into the CP 545 (A).
Configure the Input as follows
E1
The input's status should be specifically programmed wh/several CP 545's need to communicate
together via RS 232 or with GSM Docking station.
Thus, each Chronoprinter will be able to receive recorded information at the Start and Finish point.
5.8.5.
LCD Contrast
LCD scre/Backlight adjustment with
setting)
5.8.6.
LCD Backlight
Adjusts the brightness of LCD Backlight.
100% is the default setting (with an external power supply connected)
30% is the default setting (wh/running only on internal batteries)
It is recommended to set the value at 0% during daylight conditions to guarantee the best internal
battery life.
5.8.7.
Lighting Off Time
Sets the time that the Backlight stays ON betwe/two impulses.
Adjust with
A shorter time ensures a better operational autonomy.
This function is not in use wh/the CP 545 is powered.
5.8.8.
LCD Delay
LCD duration of the currently displayed information. Adjust with
th/validate
TAG Heuer Timing
Transmit
Close
Received
E2
E3
CP 545 (A) – Start
E2
E3
E4
▲
plus /
▼
less, and validate with
◄┘
(5 seconds is the default setting)
(E1 –
E4) normally before a timing impulse is received.
E4
CP 545 (B) – Finish
E1
E2
▲
plus /
▼
less, and validate with
◄┘
E3
E4
◄┘
(30% is the default
▲
Plus /
▼
Less,
Page 12 / 49
Advertisement
Table of Contents
