TAG Heuer Chronoprinter 540 User Manual page 6

INNOVATION
The CP540 provides a visual (on the LCD) and audio alarm if an external input remains in
short-circuit. This feature allows you to observe the status of TAG Heuer's new "direct-
response" photocells (HL2-31 & HL2-35 – serial number up to 7000) and allows the
timekeeper to instantly determine if a photocell is out of alignment.
3) The same message is printed with the device N° (ID) and the software version, along with the
timing mode and the main parameters used during your last timing session.
4) If the CP540 doesn't print, enter the menu (F), select
should check your batteries and replace if necessary.
5) Example of how to start a new Timing session:
a) Enter into the menu (F)
b) Clear the memory.
c) Timing mode (you may change this if desired)
d) Parameter (If changes are needed – Precision, Blocking, etc.)
e) Synchro (manual at Time of the Day to correspond with other systems, or time proposed
by you on the CP540, or start at 00:00)
f) Open a new run (begin the timing session)
PLEASE NOTE
If the same Timing Mode is reconfirmed through this menu (Mode Chrono) sequence, the
parameters by default are restored.
TAG Heuer Timing
and validate ◄┘. You
PRINTER ON
Page 6 / 44