Advertisement
TYPE-C ASSEMBLY INSTRUCTIONS
1
Switch
Wire
Housing
Connector
If your fan does not have pin connectors
on the wires coming from the switch
housing, install the wiring harness
provided. Using the provided wire
connectors connect the white wire from
the fan to the white wire from the wire
harness and connect the black or blue
wire from the fan to the black wire from
the wire harness.
3
Lower
Switch
Housing
Switch
Housing
Screw
Lift the lower switch housing up so
that the screw holes line up with the
holes in the upper switch housing.
Install the switch housing screws and
tighten securely.
8
M8505-01 • 11/21/12
1.888.830.1326
2
Feed the wires through the center hole in
the switch housing. Then using the single
pin connectors, connect the black or blue
wire from the fan to the black wire from
the light kit. Connect the white wire from
the fan to the white wire from the light kit.
4
Upper
Threaded
Switch
Rod
Housing
Lift the light kit up, tucking the wires into
the hole in the switch housing. Install the
center stem of the light kit into the lower
switch housing by turning the threaded
rod clockwise into the threaded hole.
Continue turning until tight.
Do not allow the light kit to hang
only by the wire connections!"
TYPE-C ASSEMBLY INSTRUCTIONS (CONTINUED)
5
Grommeted
Pull Chain
Hole
After the light kit is mounted to the
fan, feed the pull chains from the fan's
switch housing and the light kit through
the grommeted holes in the base of the
light kit. Extension chains are provided,
if necessary. Both pull chains must
line up with the grommeted holes to
operate properly.
7
Tab
Indentation
Installing the globe (sold separately)- Position the
indentations in the outer rim of the globe so that they
line up with the tabs on the inside surface of the light
fixture rim. Carefully lift the globe up inside the light
fixture as far as it will go. Rotate the globe in a clockwise
direction until it is held tightly in place by the four tabs.
M8505-01 • 11/21/12
1.888.830.1326
6
Socket
Installing the bulb - Install a bulb into each
of the sockets. When necessary, replace
with bulbs of the same type and wattage.
8
Installing the Pull chain pendant -
Attach the pull chain pendant to the
end of the short chains coming from the
switch housing and the light kit. Turn
power on. Your installation is complete.
9
Advertisement
