Headset; First Time Operation; To Get An Image; To Set A New Language - FLIR ThermaCAM PM575 Operator's Manual

[4.1.5 — Headset]
[2] Pass the thin straps through the slots on the left and right back side of the
camera. Insert the wire hook through the holes at the end of the straps. Lock
the mechanism by pulling forward the safety clasp.
[3] Adjust the length of the shoulder strap so that the camera rests comfortably on
the chest.
4.1.5

Headset

[1] Connect the headset to the headset connector of the camera.
[2] Place the headset on your head with the plastic support above your ear on the
opposite side of the headphone.
[3] Adjust the position of the microphone to about 2–3 cm from your mouth.
The headset can be used with the headphone either to the left or to the right. On
the cable there is also a clip to fasten the cable to the operator.
4.2

First time operation

4.2.1

To get an image

[1] Insert the battery into the battery compartment on the back of the camera.
[2] Remove the lens cover from the camera.
[3] Press the green on/off button to start the camera. After approx. 15 seconds an
image with the FLIR logotype will appear and will be displayed until the camera
controls are ready for use.
[4] Adjust the viewfinder focus to obtain the best display focus for your eyes.
[5] Point the camera at a warm object to be viewed, like a face or a hand.
[6] Press the A button to activate the auto-adjust function to achieve in a good
image in the viewfinder.
[7] Adjust the focus of the camera by moving the joystick up/down.
4.2.2

To set a new language

If the camera is set to the wrong language, press the ↵ button to display the menu
system.
[1] Go to Local adapt... in the Set-up menu (Setup → Local adapt...). Press ↵
which makes the Setup – Local adaptations panel appear.
[2] Choose Language (Setup → Local adapt... → Language) and select the desired
language by moving the joystick to the right or left. When the correct language
is shown press ↵ to set the language.
10 ThermaCAM™ PM575/595 Operator's Manual