Getting Started; Adjusting And Connecting System Components; Lenses; Pc-Card - FLIR ThermaCAM PM575 Operator's Manual

4

Getting started

4.1

Adjusting and connecting system components

4.1.1

Lenses

The camera is equipped with a built-in 24° lens, but optional lenses can also be fit-
ted.
[1] To mount the lens push the lens carefully into the bayonet of the camera, align-
ing the white dots on the camera bayonet and the lens. Turn the lens 45° clock-
wise to lock the lens.
[2] To release the lens turn it 45° counter-clockwise and remove the lens.
[3] The lens type is recognised by the camera and the correct calibration is auto-
matically used.
4.1.2

PC-card

The recorded images with voice and text comments are stored on a removable
PC-card.
[1] To insert the PC-card open the hatch by pressing the release button on the
back of the camera downwards. Insert the disk with the connector side (i.e. the
bottom side of the disk) to the right and the connectors facing the camera.
[2] To remove the PC-card open the hatch and press the eject button.
After the PC-card has been inserted, the camera software will check that it hasn't
got any errors. This will be indicated in the viewfinder by the words Checking disk.
4.1.3

Battery

[1] To insert the battery pack open the hatch by pressing the release button down-
wards on the back of the camera. Insert the battery with the connectors facing
the camera and with its convex side facing downwards.
[2] To remove the battery open the hatch and press the battery release button
below the battery.
See also "Battery system" on page 42.
4.1.4

Shoulder strap

[1] To fit the shoulder strap to the camera, pull back the safety clasp at the end of
the shoulder strap by pressing the release button.
© FLIR Systems AB – Publ. No. 557 369 – Ed. A
[4 — Getting started]
9