Connection With External Devices Using The Usb 2.0 Port - Panasonic AJ-HPX2100E Operating Instructions Manual

Connection with external devices using the USB 2.0 port

Connection with a PC in the USB DEVICE mode
By connecting AJ-HPX2100 with an external PC using USB 2.0, the P2 card connected to AJ-HPX2100 can be used as a
mass storage device.
Procedures for establishing a connection
with a PC
1
Connect the USB cable to the USB 2.0 port.
Notes
The USB 2.0 cable is not included with the camera-
recorder. Please use a commercially available USB
2.0 cable (shield with a ferrite core).
The length of the USB cable shall be not exceed 3
meters. Using a USB cable whose length is greater
than 3 meters might result in erroneous operations.
2
Navigate the menu to open the SYSTEM MODE
screen on the SYSTEM SETTING page. Then, set the
PC MODE SELECT menu option to USB DEVICE
and the PC MODE option to ON.
# < SYSTEM MODE >
SYSTEM MODE
REC SIGNAL
CAMERA MODE
VF TYPE
PC MODE SELECT :DEVICE
#
PC MODE
Note
The function of the menu option USB may be
assigned to a desired user button by using any one of
the menu options USER MAIN SW, USER1 SW or
USER2 SW.
These options can be found in the USER SW screen,
which is accessible from the CAM OPERATION page.
When you establish the USB connection for the first time,
install the accessory P2 software for AJ-HPX2100 on the
PC. Refer to the Installation Manual for the details.
120 Connection with external device : Connection with external devices using the USB 2.0 port
USB 2.0 port
(DEVICE)
:1080i-59.94i
:CAM
:60i
:HD
:ON
Notes
A USB driver must be installed on the PC.
AJ-HPX2100 is only applicable to USB 2.0, not to
USB 1.1.
Only one unit at a time must be connected to the
PC via USB.
The P2 card must not be removed when it is
connected via USB.
While a USB connection is established, the P2
card's access LED should not be lit except when
access is being carried out.
When a USB device is active, recording, playback,
or navigation through clip thumbnails is disabled.
During a USB connection, the USB LED on the side
panel stays illuminated. Also, "USB DEVICE" is
displayed in the system information/warning area in
the viewfinder.
When the connection is not correctly established,
both of these indications blink.
8 6 % ' ( 9 , & (
 )         

 $   E% )         
3
There are two ways to terminate the USB mode, as
follows:
Turn the POWER switch of AJ-HPX2100 OFF.
Set the PC MODE item to "OFF" from the menu
operations.
USB LED
w
)   = 
w