Features Of The Input/Output Unit; Other Features - Panasonic AJ-HPX2100E Operating Instructions Manual

Features of the Input/Output unit

_ Features USB2.0 port (HOST/DEVICE)
By connecting with a PC via USB2.0, a P2 card
inserted in AJ-HPX2100 can be used as a bulk
storage device.
It is also possible to store data on a P2 card onto a
USB 2.0-connected external hard disk equipped with
USB host capability as well as view clips stored on
hard disks and write them to P2 cards.
_ DVCPRO (IEEE1394) output and DV output
provided as a standard configuration
Data can be input/output to an external device through
the IEEE 1394 digital interface. Use a 6-pin type
connector. The unit does not support the bus power.
_ HD/SD SDI output featured as standard
Video can be output as HD SDI signals, down-
converted SD SDI signals, or analog composite
signals. SDI output includes embedded audio etc..
Note that the SD mode does not output HD SDI
signals.
_ Down converter output provided as a standard
configuration
In HD mode, the MON OUT output connector and the
VIDEO OUT connector (in setting VBS mode) output
down converter (analog composite) signals.
It is optimum for confirming shot images on the SD
monitor. (Refer to page 39)
_ Viewfinder connection
From the viewfinder connector of the unit, 1080-59.94i,
1080-50i, 480-59.94i or 576-50i signals are output.
Furthermore, signals are output for switching the
frequencies of the connected viewfinder.
Confirm images in multi formats by connecting the
viewfinder (AJ-HVF21G), which is available as an
optional accessory. (Refer to page 50)
While the AJ-VF20WBP (59.94 Hz)/E (50 Hz) can also
be connected, you cannot view video in formats with
different frequencies.
10
General Features of the Input/Output unit
_ HD/SD SDI input function (when the AJ-
_ Remote control connector
_ Confirmation of return video signals
_ DC OUT connector

Other features

_ User button
YA350G is attached)
AJ-HPX2100 with the AJ-YA350G extension board
attached can record SDI signals input through the SDI
input connector only if the signals are in the same
format as AJ-HPX2100.
By connecting the remote control unit (AJ-RC10G),
which is available as an optional accessory, the unit
can be controlled remotely. (Refer to page 98)
It is possible to confirm the return video signals
(analog HD-Y signals in the HD mode/VBS or Y
signals in the SD mode) supplied to the GENLOCK IN
connector of AJ-HPX2100 in the viewfinder to confirm
programs.
(Only video signals from the same record format can
be confirmed.) (Refer to page 160)
The DC OUT connector of the unit produces 1.5 A of
electrical current.
By connecting an external switch to this connector, it is
possible to control REC start/stop.
Since a tally lamp can be used by connecting the LED
to this connector, it is useful for shooting video when
fixing the camera on a crane. (Refer to page 99)
On the side panel of the unit, three user buttons
(USER MAIN/USER1/USER2) are available.
Each button can be assigned the on/off function for
any frequently used feature selected from among the
many features of the unit, such as digital zooming and
super gain (Refer to page 46).