Subscribe to Our Youtube Channel
Related Manuals for ORTEC 9302
Summary of Contents for ORTEC 9302
- Page 1 Model 9302 Amplifier-Discriminator Operating and Service Manual ® Printed in U.S.A. ORTEC Part No. 733690 1202 Manual Revision C...
- Page 2 In the event ORTEC fails to manufacture or deliver items called for in this agreement or purchase order, ORTEC’s exclusive liability and buyer’s exclusive remedy shall be release...
-
Page 3: Table Of Contents
CONTENTS WARRANTY ............... ii SAFETY INSTRUCTIONS AND SYMBOLS . -
Page 4: Safety Instructions And Symbols
SAFETY INSTRUCTIONS AND SYMBOLS This manual contains up to three levels of safety instructions that must be observed in order to avoid personal injury and/or damage to equipment or other property. These are: DANGER Indicates a hazard that could result in death or serious bodily harm if the safety instruction is not observed. -
Page 5: Safety Warnings And Cleaning Instructions
SAFETY WARNINGS AND CLEANING INSTRUCTIONS DANGER Opening the cover of this instrument is likely to expose dangerous voltages. Disconnect the instrument from all voltage sources while it is being opened. WARNING Using this instrument in a manner not specified by the manufacturer may impair the protection provided by the instrument. -
Page 7: Description
X20 and is 5 mV when the gain switch is set at X200. Protection is provided for The ORTEC 9302 is a fast amplifier and input voltages of up to ±100 V at a 10% duty cycle. -
Page 8: Input
The low input impedance (50 ) and low output 3.2. CONNECTION TO POWER impedance (50 ) of the 9302 permit it to be used in a system using only 50 cable. The low output The 9302 contains no internal power supply, and... -
Page 9: Maintenance
Pulses from the measurements is ion counting. This technique can photomultiplier tube are applied to the 9302, where be applied to mass spectrometry, and has the same they are first amplified. Following amplification, the sensitivity advantages with an electron or ion... - Page 10 Fig. 5.1. Block Diagram of a Typical 1 MHZ Ratemeter System. Fig. 5.2. Ion Counting System with Digital and Analog Outputs.
- Page 11 Coaxial *17 - 12 V Coaxial Spare bus Coaxial Reserved bus *41 117 V ac (neutral) Spare *42 High-quality ground Spare Ground guide pin Reserved Pins marked (*) are installed and wired in ORTEC’s 4001A and 4001C Modular System Bins.
Need help?
Do you have a question about the 9302 and is the answer not in the manual?
Questions and answers