Subscribe to Our Youtube Channel
Related Manuals for ORTEC FTA820A
Summary of Contents for ORTEC FTA820A
- Page 1 Model FTA820A Octal Fast Timing Amplifier Model FTA420C Quad Fast Timing Amplifier Operating Manual ® Printed in U.S.A. ORTEC Part No. 740350 1002 Manual Revision D...
- Page 2 In the event ORTEC fails to manufacture or deliver items called for in this agreement or purchase order, ORTEC’s exclusive liability and buyer’s exclusive remedy shall be release of the buyer from the obligation to pay the purchase price.
-
Page 3: Table Of Contents
CONTENTS SAFETY INSTRUCTIONS AND SYMBOLS ..........iv SAFETY WARNINGS AND CLEANING INSTRUCTIONS . -
Page 4: Safety Instructions And Symbols
SAFETY INSTRUCTIONS AND SYMBOLS This manual contains up to three levels of safety instructions that must be observed in order to avoid personal injury and/or damage to equipment or other property. These are: DANGER Indicates a hazard that could result in death or serious bodily harm if the safety instruction is not observed. -
Page 5: Safety Warnings And Cleaning Instructions
SAFETY WARNINGS AND CLEANING INSTRUCTIONS DANGER Opening the cover of this instrument is likely to expose dangerous voltages. Disconnect the instrument from all voltage sources while it is being opened. WARNING Using this instrument in a manner not specified by the manufacturer may impair the protection provided by the instrument. -
Page 7: Description
The Model FTA820A and FTA420C Fast Timing Both units are single-width NIM modules. The Amplifiers are high-performance, wide-bandwidth FTA820A is an 8-channel unit with a gain of 200, amplifiers designed for boosting very fast linear noninverting. The 4-channel FTA420C offers a gain signals from photomultipliers, electron multipliers, of 20, noninverting. -
Page 8: Circuit Description
5. MAINTENANCE The FTA820A and FTA420C require very little maintenance other than routine removal of dust and tightening of mechanical connections. Be sure to observe the cleaning instructions and safety warnings at the front... - Page 9 Reset (Auxiliary) +12 V Coaxial Coaxial 12 V Spare Bus Coaxial Reserved Bus 117 V ac (Neutral) Spare High-Quality Ground Spare Ground Guide Pin Reserved Pins marked (*) are installed and wired in ORTEC’s Model 4001A and 4001C Modular System Bins.
Need help?
Do you have a question about the FTA820A and is the answer not in the manual?
Questions and answers