Garland Mealstream Service Manual page 29

PROCEDURE
FOR
Step 2: Insert S10 10mm spacer into door.
(See figure 1 below for inserting spacer
correctly).
Step 3: Remove S10 10mm spacer and insert S1 1mm
spacer into the door and close the door.
Step 4: Remove S1 1mm spacer and insert S5 5mm
spacer into the door and close the door.
then check the microswitches are functioning correctly and repeat steps 1 to 4.
After carrying out this procedure make sure that the interlock monitor switch is properly connected
Figure 1
Door side seal
It is very important after completing this procedure to carry out a
DOOR INTERLOCK ADJUSTMENT
If an oven fails this sequence
according to the circuit diagram on pages 44-46.
Door spacer
The door spacer must always be
located on the point where the side
seals and top seals meet.
microwave leakage test procedure. See pages 22-23.
Mealstream Ovens Pt. No. 32Z3403 Issue 15
Interlock
SW1 (Monitor)
SW2 (Primary)
SW3 (Secondary)
Interlock
SW1 (Monitor)
SW2 (Primary)
SW3 (Secondary)
Interlock
SW1 (Monitor)
SW2 (Primary)
SW3 (Secondary)
Please note.
Page 29
TEST (3)
AND
Order
CLOSED
OPEN
OPEN
Order
OPEN
CLOSED
CLOSED
Order
OPEN
OPEN
OPEN
Door top seal