Merging Pyramix User Manual page 584

Automation Snapshot Range Last Selection Applies the last Snapshot Range without the need to open the Filter automa-
Delete Selected Points & Interpolate Deletes all automation points contained in the selected Region and interpolates
Delete Selected Points
Cut Selected Points
Copy Selected Points
Paste Points to Cursor
Paste Points to Original TC
Bus Reassignment on Paste
Auto-Write Mode - Write & Release The automation starts writing a new pass when the control is touched and stops writing
Auto-Write Mode - Write & Hold
Auto-Write Mode - Trim & Release The automation starts updating the current pass when the control is touched and stops
Auto-Write Mode - Trim & Hold
Release Mode - Snap
Release Mode - Auto-Release
Release Mode - Write to Next
Release Mode - Write to End
Release Auto-Writing
Automation Tracks
Automation Settings
tion Tracks to Snapshot window. Ctrl + Click on the double Camera button does the
same thing. I.e. the last selection is applied directly thus improving the workflow.
Note: The the last entry is lost after a Mixer rebuild so, if a rebuild occurs between Snap-
shots the Filter automation Tracks to Snapshot Window will open.
between the last existing point before the selection and the first point after the selection.
Deletes all automation points contained in the selected Region.
Cuts all automation points contained in the selected Region
Copies all automation points contained in the selected Region
Pastes all copied or cut automation points at the cursor on the selected Track
Pastes all copied or cut automation points at the Original TimeCode on the selected Track
When set on the Automation Buses Reassignment dialog will appear if some auto-
mated bus elements of a strip are available in the automation clipboard. When set off the
dialog will appear only when at least one bus in the clipboard is not available in the tar-
get mixer.
when the control is released.
The automation starts writing a new pass when the control is touched. The value when
the control is released will continue to be written until the transport stops.
updating when the control is released.
The automation starts updating when the control is touched but continues when the
control is released and stops only when the transport stops.
A straight jump is made from the current control value to the value written in the previ-
ous pass.
An interpolation is created from the current value to the value written in the previous
pass. I.e. a fade. The length of this is defined in Automation Settings > Auto-Release
Time .
The same value is kept after the last written point until the next point is found in the pre-
vious pass.
Writes the current value to the end, ignoring previously written points. (If any)
Immediately releases all controls currently recording automation
Opens the Automation Tracks window. This view allows the automation versions for a
specific control to be displayed. Once the desired control has been located in the tree
view, simply double-clicking on the control will update the Automation Track Versions
window
Opens the Settings > All Settings > Application > Automation page which allows
automation parameters and settings to be defined
Menus : Automation 27 - 584