Ip Specific Serial Commands - Hall Research Technologies VSM-A-4-4 User Manual

User's Manual
Change Password?
Allow user to change existing password. When clicked, a new window will pop up for
entering the new password. Password length is limited to eight (8) characters long.
Apply
User must click this button after changing any field on settings tab to save changes.
Factory Reset
This button loads factory defaults to Matrix. It will reset unit to factory default values.
Factory default will also wipe out saved presets.
5.2.4 Factory Default Settings
Field Name in GUI
Power
VIDEO INPUT n
AUDIO INPUT n
VIDEO OUTPUT n
AUDIO OUTPUT n
PRESET n
Name
Location
Subnet
Gateway
DHCP
Telnet
Default Password

5.3 IP Specific Serial Commands

HSM matrix equipped with IP interface allows user to assign Static IP address using
Serial Interface with standard RS-232. Please refer section 4 to connect PC to Matrix
over serial interface. Once you are connected use following Commands to assign IP
address or load factory defaults.
5.3.1 Change network settings of unit
Note: All commands are case sensitive. Also note that you must specify a new IP
address, followed by SB and GE commands (all 3) for the new IP to take effect
Command: IP xxx.xxx.xxx.xxx«
Success Response: IP= xxx.xxx.xxx.xxx«
Possible error Responses: ERR! IP address not changed (if the specified IP address is
the same as unit's existing address), or ERR! IP address is not valid. If there is a
problem with new IP address as specified
Command: SB xxx.xxx.xxx.xxx«
Success Response: SB= xxx.xxx.xxx.xxx«
20
IP Assigned by DHCP
Based on IP
Assigned by DHCP
Login
stands for new IP address value.
stands for new Subnet Mask address value.
Default Value
Off
Vid_In_n
Aud_In_n
Vid_Out_n
Aud_Out_n
PRESET_n
VSM Matrix
Hall Research
Enabled
Disabled
Disabled
Pass
Tab in GUI
Video
Labels
Labels
Labels
Labels
Labels
Settings
Settings
Settings
Settings
Settings
Settings
Settings
Settings
Settings