Pin Assignment; 12-Pin Multi-Connector (Dc-In/Rs232C); Digital Output Connector For Eia-644 (Lvds) - JAI CV-M4+ Operation Manual

5. Pin Assignment

5.1. 12-pin Multi-connector (DC-IN/RS232C)

Type: HR10A-10R-12PB-01 (Hirose) male. (Seen from rear of camera.)
9
1
2 8
10
11
3 7
12
4
6
5
Fig. 2. 12-pin connector.

5.2. Digital Output Connector for EIA-644 (LVDS)

This pin configuration is only valid for CV-M4
Type: 26 pin MRD connector
3M 10226-1A10JL
13
26
Fig. 3. LVDS connector
The digital input and output
signals follow the EIA 644
standard. It is also called Low
Voltage Differential Signal
(LVDS). The output differential
line driver is NS type DS90C031.
Line receiver is NS type DS90C032.
The following signal are found on the Digital Output Connector:
D2 – D9
PCLK
LEN
FEN
Multi
Ext. Trigger IN
The polarity for LEN, FEN, TRIG is negative and Multi is positive as factory setting. It can be
changed by internal SW301-2 and 3 or RS 232C command FP and TP
+ +
CV-M4 /M4 CL, CV-M7
Pin no.
1
2 +12 V DC input
3
4 Video output
5
6
7
8
9 EEN/sync out
10 Trigger input
11 Multi shutter
12
*) Iris video out without sync. Refer to 5.4.1 video output
*1) EEN or c. sync out select by RS232C command SE
*2) input on 12-pin con. or LVDS/(CL) by command TP or int. SW301-1
+
/ CV-M7
Pin no.
1 14
2 15
1 2 16
4 17
5 18
6 19
14
7 20
8 21
9 22 +/-TRIG
10 23 +/-Multi Multiple exposure
11 24
12 25
13 26 +/-PCLK Pixel clock
*1) input on 12-pin con. or LVDS/(CL) by command TP or int. SW301-1
8 bit video Data out.
Pixel CLocK. One clock pulse for each video data byte.
Line ENable. A pulse for the beginning of each new line.
Frame Enable. Video frame out data is valid.
Multiple shutter. Trigger input for multiple exposures.
External trigger signal in for exposure control.
+ +
/M7 CL
Signal Remarks
GND
GND
Analogue video for test and iris control *)
GND
RXD in
Or via Camera Link for CL
if JP 301 short
TXD out
GND
*1) composite sync.
*2) Or on LVDS or Camera Link.
*2) Or on LVDS or Camera Link.
GND
+
Signal Function
+/- D2 Video output (LSB)
+/- D3 Video output
+/- D4 Video output
+/- D5 Video output
+/- D6 Video output
+/- D7 Video output
+/- D8 Video output
+/- D9 Video output (MSB)
Trigger input
+/-LEN Line enable
+/-FEN Frame enable
- 4 -
+
versions
Remarks
8 most significant bits
of the 10 bit digitized
video
*1) or TTL on #10 12 pin
*1) or TTL on #11 12 pin