Replacing The Roller Belt And Feed Roller - Toshiba B-SX6T SERIES Maintenance Manual

3.MAIN UNIT REPLACEMENT
EO18-33017

2.8 Replacing the Roller Belt and Feed Roller

2.8 Replacing the Roller Belt and Feed Roller
1. Lower the Pinch Roller Lever.
2. Remove the Plastic Head Screw to detach the Ribbon End Sensor Plate.
3. Remove the FL-3x5 screw, cut the Cable Band, and remove the Head-up Switch.
4. Detach the connector of the Ribbon End Sensor.
5. Remove the Pinch Roller Block.
Cable Band
FL-3x5 Screw
Connector
Plastic Head Screw
Pinch Roller Block
Ribbon End Sensor Plate
Notch
Head Up Switch
Pinch Roller Lever
Stud
NOTE: Fit both sides of the studs into the notches when installing the Ribbon End Sensor Plate.
6. Remove the four E-5 retaining rings, Pinch Roller Holder, Bush, Pinch Roller Washer, and then Roller
Belt.
E-5
E-5
Bush
Pinch Roller Holder
Pinch Roller Washer
Roller Belt
2-12