Toshiba B-SX6T SERIES Maintenance Manual page 14

3.MAIN UNIT REPLACEMENT
CAUTION!
Orient the screws so that they are vertically aligned with the Solenoid Attachment Plate.
6. Remove the Head Cover Plate. (Refer to Section 2.5.)
7. Insert piled 10 pieces of tag paper of 8 inches or 6 inches (203.2 mm or 170.6 mm) in width, 0.16 mm in
thickness (I-BEST-S is recommended.) between the Print Head and the Platen. Then, turn the Head
Lever to the LOCK position.
8. Push and hold the Head Up Link against the Solenoid ( ), and then press and fit the Solenoid Unit
snugly to the Head Up Link ( ). Secure the Solenoid Unit with the screws.
9. Reassemble in the reverse order of removal.
Thickness: 1.6 mm
Head Up Link
Push
Print Head
2.6 Replacing the Solenoid (Standard on the B-SX8T, Option for the B-SX6T)
Push
Platen
2- 10
EO18-33017
Solenoid Unit