Silicon Graphics 1200 User Manual page 35

007-4248-001
Tip: Make sure you install the rails level. Count the holes on the rack rails from the
bottom of the rack carefully on each side. Make sure the ends of the brackets face
toward the front of the rack.
As one person holds each bracket, the other person lines up the front screw


holes and attaches the 10-24 rack screws on the right and left sides.
From the sides of the rack, line up the four screw holes on each side of the rear


mounting bracket and extender, and install four 1/4-inch (0.64 cm) length 10-32
screws and 10-32 nuts on the inside.
At the back of the rack, line up the rear screw holes and attach the 10-24 rack


screws on the right and left sides.
7. With one person holding each side, slide the SGI 1200 server chassis with slides
attached onto the rails into the rack. Line up the slides and rails carefully on each
side, press the locking tabs, and slide the chassis into the rack. See Figure 3-1.
8. Install two 10-24 rack screws at the front of each rail to secure the slide rail. The
server chassis is now securely attached to the rack.
Mounting the System in a Rack
21