Mounting The Server In A Rack; Mounting The System In A Rack - Silicon Graphics 1200 User Manual

3.

Mounting the System in a Rack

007-4248-001
Chapter 3

Mounting the Server in a Rack

This chapter provides illustrations and procedures used to mount your SGI 1200 server
in a 19-inch equipment rack.
This section provides information about installing the SGI 1200 server into a rack. Before
you begin, check Table 3-1, Table 3-2, and Table 3-3 to make sure that you have the
hardware necessary to complete the installation.
Warning:
Service personnel could be seriously injured and equipment damaged if
the rack topples over. Make sure that only one SGI 1200 server at a time in the rack is
extended forward on slides. Install all equipment into the rack from the lowest
available position. The rack must be anchored to the floor with stabilizing feet to
enhance stability. Also, make certain that the rack has sufficient power for the server's
needs. Check with the appropriate facilities authorities before installing this server
into a rack.
Note: This installation requires two people and a #2 Phillips screwdriver.
Tip: After you have removed the server from its shipping materials, remove the
shipping tape (if any) that secures the removable hard drives during transit.
19