Table 5-8 Quick Setup Tcp/Ip Settings (Remote Wireless Bridge Mode) - ZyXEL Communications ZyAIR B-5000 User Manual

ZyAIR B-5000 User's Guide

Table 5-8 Quick Setup TCP/IP Settings (Remote Wireless Bridge Mode)

LABEL
TCP/IP Settings
Bridge IP Address
Bridge Subnet
Mask
Default Gateway
DNS Server
General DHCP Server Parameters
DHCP Service
Assign Default
Gateway
Assign net Mask
DHCP Start/End IP
Apply Interface
Back
NEXT
5-14
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default.
Type the subnet mask assigned to you by your ISP (if given).
Enter the IP address of the default gateway.
The ISP dynamically assigns DNS server information (and the ZyAIR's WAN IP
address). The field displays the DNS server IP address that the ISP assigns.
Select Enable or Disable to activate or deactivate DHCP Service, factory default is
Disabled. When configured as a server, the ZyAIR provides the TCP/IP configuration
for the clients. If this is set to Disable, DHCP service will be disabled and you must
have another DHCP server on your LAN, or else the computers must be manually
configured.
Enter the IP address of the default gateway.
The DHCP server assigns a subnet mask to the PHCP clients.
DHCP Start IP and End IP provide a range of addresses for your network.
Use the drop-down list to select WLAN to make DHCP services available for the
wireless network or select Ethernet, to make DHCP services available for the wired
network.
Click Back to return to the previous screen.
Click NEXT to continue to the wireless setup screen.
DESCRIPTION
Bridge Quick Setup