Table of Contents
Advertisement
ZyAIR B-5000 User's Guide
Step 7.
Set wireless parameters on client stations PC1, PC2 and PC3 as SSID (wireless).
Step 8.
Left side stations are transparent to the right side network.
Step 9.
The DHCP server assigns IP address to PC1, PC2 and PC3.
21.1.2
Configure the ZyAIR as a Wireless Access Router with PPP over
Ethernet (PPPoE)
Step 1.
Select ACCESS POINT as the operating mode, click NEXT.
Step 2.
Click ADVANCED CONFIG.
Step 3.
Select Bridging Parameters.
Step 4.
Select Disable for Bridge Function.
Step 5.
Click FINISH.
Step 6.
If you are an PPPoE subscriber, you will need to specify your ISP PPPoE username and
password to enable PPPoE broadband access. Click BASIC CONFIG.
Step 7.
Select ISP Parameters.
21-2
Figure 21-1 Wireless Access Bridge
Configuration Scenarios
Advertisement
Table of Contents
