ZyXEL Communications ZyAIR B-5000 User Manual page 155

Step 8.
Click MODIFY to setup the correct ISP parameters: ISP Name, ISP Phone, Username and
Password. Click OK.
Your Internet Provider should give you all the information you need.
Step 9. Click BASIC CONFIG.
Step 10. Select Interface Parameters and select the required interface.
Step 11. Click MODIFY to choose the interface you want to change.
Step 12. In interface 1, ensure that the wireless interface Status is set to Active, enter the IP address and
enter the Net Mask that is suitable for your wireless network. Turn NAT (PAT) 'off'.
Step 13. In interface 2, ensure that the wireless interface Status is set to Active, and enter the Ethernet
IP address and Net Mask of the Ethernet interface. Turn NAT (PAT) 'on'.
Step 14. In interface 3, ensure that the PPPoE interface Status is set to Active, and enter the Ethernet IP
address and Net Mask. Choose the ISP index that you have configured in Step 1. After that,
follow the default setting.
Step 15. Click the OK button to return to the Interface Parameters window.
Step 16. Click FINISH.
Ensure that interface 3 within Status is set to Disable. Choose NAT (PAT) in each
interface to enable NAT (PAT) services. For example, ensure PPPoE interface
within NAT (PAT) is set to 'On' and the others are set to 'Off'. This means that
every communication through the PPPoE interface is applied to NAT (PAT).
Step 17. The ZyAIR supports PPPoE auto dial-up; make sure your default route is set to zero. Click
BASIC CONFIG.
Step 18. Select System Setup. In the System Setup page, enter the Default Route as 0.0.0.0,
192.168.2.254 is the factory default.
Step 19. Click the FINISH.
Step 20. Click BASIC CONFIG.
Step 21. Select DHCP Parameters and make sure the DHCP Client Setting is set to Disable.
Step 22. Click FINISH.
Step 23. Set Basic Configuration - Wireless LAN parameters on the ZyAIR: Channel and SSID
(wireless).
Step 24. Turn on the DHCP server on the ZyAIR and assign IP addresses to PC1, PC2 and PC3.
Step 25. Set wireless parameters on client stations PC1, PC2 and PC3: SSID (wireless).
Configuration Scenarios
ZyAIR B-5000 User's Guide
21-3