Permit (Ipv6 Standard Format); Permit (Ipv6 Extended Format) - Zte ZXR10 Command Manual

ZXR10 Command Manual (Security Volume)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Example
Related
Commands
Purpose
Command Modes
Syntax
24 Confidential and Proprietary Information of ZTE CORPORATION
deny
permit (IPv6 Standard
Format)
Use this command to configure the permit conditions for an IPv6
standard access list. Remove the permit conditions with the no
form of this command.
IPv6 standard ACL configuration
permit <source/prefix>[time-range <timerange-name>]
no permit <source/prefix>[time-range <timerange-name>]
<source/prefix>
time-range <timerange-
name>
This example describes how to allow accessing to a host on the
specified network.
ZXR10(config)#ipv6 acl standard number 1
ZXR10(config-std-v6acl)#permit 1030::C9B4:FF12:48AA:1A2B/60
deny
permit (IPv6 Extended
Format)
Use this command to configure the permit conditions for an IPv6
extended access list. Remove the permit conditions with the no
form of this command.
IPv6 Extended ACL configuration
deny <protocol><source/prefix><destination/prefix>[time-ra
nge <timerange-name>]
no deny <protocol><source/prefix><destination/prefix>[time-r
ange <timerange-name>]
Host or source network of sending packets
(in dotted hexadecimal format)/IPv6
address prefix length, the keyword any
is used as the abbreviation for the prefix
length 0 to indicate any source ip address
Time range name, the length is not more
than 31 characters