Table of Contents
Advertisement
Appendix
Troubleshooting
My corded phone is ringing, but my headset is not ringing.
• Make sure that
Make sure that LIFTER MODE light on the TL7610/TL7612
headset base is on, or the CORDED HANDSET CONNECTED
switch is turned to YES on the TL7810/TL7812/TL7910/TL7912
headset base. Press the MODE button on the TL7610/TL7612
headset base, or the PHONE/PC button on the TL7810/
TL7812/TL7910/TL7912 headset base to change the mode.
• Make sure that the RING ON/OFF button on the lifter is turned
on. If the RING ON/OFF button is turned off, the headset does
not ring.
• If the speaker of your corded phone is not located under
the lifter, install the auxiliary ring detector. See page 16 for
instructions.
• It may be necessary to adjust the sensitivity level of the ring
detector. See page 17 for instructions.
• If an auxiliary ring detector is used, make sure its cord is
completely plugged into the handset lifter.
• Make sure all cords and the telephone line cord are plugged
into the appropriate outlets.
• Make sure your headset is charged.
The other party cannot hear my voice during a call.
• Make sure your headset microphone is not muted.
•
During a call, slide the LIFTER AUDIO ADJUST switch at the
side of the TL7610/TL7612 headset base from A to G, or the
LIFTER AUDIO ADJUST switch at the bottom of the TL7810/
TL7812/TL7910/TL7912 headset base from A to F until you
obtain good sound quality.
23
Advertisement
Table of Contents
