Table of Contents
Advertisement
Getting started
Headset base installation - TL7610/TL7612
TL7610/TL7612 headset base installation (cont.)
3.
Plug one end of the telephone line cord (provided with the
headset base) into the base handset jack on the telephone
where the curly handset cord was plugged in.
Plug the other end of the line cord into the BASE JACK
4.
(orange dot) on the headset base.
5.
Plug the lifter control cable into the jack of the TL7610/
TL7612 base adapter.
6.
Plug the other end of the TL7610/TL7612 base adapter into
the LIFTER jack (blue dot) on the headset base.
7.
After completing installation, slide the rear bottom piece
towards the headset base until it clicks into place.
8.
Adjust the corded handset audio (see page 6) before you
install the handset lifter on your corded phone.
9.
For instructions of installing the lifter, see pages 12-14. For
information about the internal and auxiliary ring detectors,
refer to pages 16-18.
5
Advertisement
Table of Contents
