Transmitting A Call - Icom IC-F3262DT Operating Manual

■ Transmitting a call

dPMR operation allows you to make a call to a specific sta-
tion (Individual call) or to a particular group (Talkgroup call).
Other digital mode transceivers on the channel will not re-
ceive a call that does not match their Individual or Talkgroup
ID and/or colour code.
D General
• Editing an ID
If the transceiver has a key assigned to the TX Code Enter
function, you can edit an ID within the allowable digits.
Push [TX Code Enter] to enter the ID edit mode.
q
• The digit to be edited blinks.
w Push [TX Code Enter] to select a desired digit to be ed-
ited.
e Push [CH UP] or [CH DOWN] to select a desired num-
ber.
r Push [TX Code Enter] to set. The digit to the right will
automatically blink.
Repeat step e and r to input all allowable digits.
t
[TX Code Enter] to store the setting.
After editing, push
y
• The transceiver returns to the stand-by mode.
NOTE: Changing the channel or turning OFF the trans-
ceiver discards the new ID, and returns the original one.
• When no acknowledgement is received
After making a call, the transceiver waits for an acknowledge-
ment for the preprogrammed time period. If no acknowledge-
ment is received, the transceiver automatically repeats the
call 4 times (default). However, when no acknowledgement
is received after each of the calls, an error beep sounds and
"FAILED" is displayed. In that case, the transceiver automati-
cally returns to the stand-by mode.
• About the 10-key version
If the 10-key version is used, the keypad allows you to:
- Select an ID list number while in the ID selection mode.
- Select a Status list number while in the status message se-
lection mode.
- Select an SDM list number while in the SDM selection
mode.
- Edit an SDM while displaying it. (p. 22)
NOTE: Depending on the preprogrammed settings, addi-
tional functions can be used only with the 10-key version.
Ask your dealer for details.
3
dPMR OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
18