Epson dreamio EH-R4000 User Manual page 48

Configuration Menu Functions
Gateway Address
You can input the IP address for the gateway for the projector. You can enter a number from 0 to 255 in
each field of the address. However, the following gateway addresses cannot be used.
0.x.x.x, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Mail
Mail Notification
You can set whether or not (On/Off) to be notified by e-mail.
SMTP Server
You can input the IP Address for the SMTP Server for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following IP Addresses
cannot be used.
0.x.x.x, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Port Number
You can input the Port Number for the SMTP Server. The default value is 25. You can input numbers
between 1 to 65535.
Address 1-3 Setting
Input the Email Address and the contents of the Mail to receive notification when an abnormality or
warning occurs in the projector. You can enter up to 32 single-byte alphanumeric characters for the e-
mail addresses. You can select multiple problems or warnings to be notified about by Mail. You can also
change each Email Address.
AMX Device Discovery
When the projector is connected to a network, set this to "On" to allow the projector to be detected by
AMX Device Discovery. Set this to "Off" if you are not connected to an environment controlled with a
controller from AMX or AMX Device Discovery.
Reset
To reset all of the Network settings, select "Yes".
46