Power Connector - HP EliteBook Folio 9480m Maintenance And Service Manual

Power connector

Description
Power connector
Before removing the power connector, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive cover (see
b. Hard drive (see
c. Service cover (see
d. Keyboard (see
e. Base enclosure (see
Remove the power connector:
1. Position the base enclosure with the front toward you.
2. Disconnect the power connector cable from the system board (1).
3. Lift the power connector from the computer (2).
4. Remove the power connector.
Reverse this procedure to install the power connector.
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 35), and then remove the following components:
Hard drive cover on page
Hard drive/SSD drive on page
Service cover on page
Keyboard on page 51)
Base enclosure on page
38)
39)
44)
58)
Spare part number
702875-001