Display Assembly - HP EliteBook Folio 9480m Maintenance And Service Manual

Display assembly

This section describes removing components that require you to completely remove the display panel. For
more information about removing display components that do not require that you remove the assembly
from the computer, see
NOTE: The display assembly is spared at the subcomponent level only.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive cover (see
b. Hard drive (see
c. Service cover (see
d. WLAN module (see
e. WWAN module (see
f. Fan (see
g. Keyboard (see
h. Base enclosure (see
Remove the display assembly:
1. Disconnect the display panel cable (1) from the system board.
2. Release the display panel cable from the routing channel (2).
72 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Display assembly components (panel, bezel, webcam, microphone) on page
Battery on page
Hard drive cover on page
Hard drive/SSD drive on page
Service cover on page
WLAN module on page
WWAN module on page
Fan on page 63)
Keyboard on page 51)
Base enclosure on page
35), and then remove the following components:
38)
39)
44)
49)
47)
58)
55.