Laser On Time; Beep After Good Decode - Motorola Symbol LS3408 Product Reference Manual

Laser On Time

This parameter sets the maximum time that decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes beginning on
Appendix D, Numeric Bar Codes
zero. For example, to set a Laser On Time of 0.5 seconds, scan the bar code below, then scan the "0" and "5" bar
codes. In case of an error, or to change the selection, scan Cancel on

Beep After Good Decode

Scan a bar code below to select whether or not the scanner beeps after a good decode. If Do Not Beep After
Good Decode is selected, the beeper still operates during parameter menu scanning and indicates error
conditions.
that correspond to the desired on time. Single digit numbers must have a leading
Laser On Time
*
Beep After Good Decode
(Enable)
Do Not Beep After Good Decode
(Disable)
User Preferences
page D-3.
4 - 5
page D-1 in