10 - 2 Symbol LS3408 Product Reference Guide
Connecting Using Scanner Emulation
To perform Scanner Emulation, connect the scanner to a mobile computer, or a controller which collects the data
and interprets it for the host.
Host Port Connector
Scanner Emulation Connection
Figure 10-1
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the scanner remain
the same.
Attach the modular connector of the Scanner Emulation interface cable to the cable interface port on the
1.
scanner. (See
Connect the other end of the Scanner Emulation interface cable to the scanner port on the mobile computer or
2.
controller.
Ensure that all connections are secure.
3.
Scan the
Scanner Emulation Host on page 10-4
4.
To modify any parameter options, scan the appropriate bar codes in this chapter.
5.
!
WARNING
Installing the Interface Cable on page
The scanner must be connected to 5 volt decoders. Damage caused by connecting the
scanner to a 12 volt decoder invalidates the warranty.
Interface cable
1-3.).
to enable the Scanner Emulation host interface.
Figure 10-1
are examples