Connecting A Synapse Cable Interface; Removing The Interface Cable; Configuring The Scanner - Motorola Symbol LS3408 Product Reference Manual

Connecting a Synapse Cable Interface

NOTE Refer to the Synapse Interface Guide provided with the Synapse cable for detailed setup instructions.
Synapse Smart Cables enable interfacing to a variety of hosts. The appropriate Synapse cable has the built-in
intelligence to detect that host.
To host
Synapse Smart Cable
Synapse Cable Connection
Figure 1-5
Plug the Synapse adapter cable into the bottom of the scanner, as described in
1.
on page 1-3.
Align the 'S' on the Synapse adapter cable with the 'S' on the Synapse Smart Cable and plug the cable in.
2.
Connect the other end of the Synapse Smart Cable to the host.
3.

Removing the Interface Cable

Loosen the two screws on the cable clamp at the bottom of the scanner and gently pull the clamp away from
1.
the bottom of the scanner.
Open the clamp and unplug the interface cable modular connector from the cable interface port on the bottom
2.
of the scanner handle. Carefully slide out the cable.
Follow the steps for
3.

Configuring the Scanner

Use the bar codes included in this manual or the 123Scan configuration program to configure the scanner. See
Chapter 4, User Preferences
menus. See Chapter 11, 123Scan
in the program.
Installing the Interface Cable on page 1-3
and each host chapter for information about programming the scanner using bar code
to configure the scanner using this configuration program. A help file is available
Getting Started
Synapse adapter cable
To scanner
Installing the Interface Cable
to connect a new cable.
1 - 5