Convert All Bar Codes To Code 39 - Motorola Symbol LS3408 Product Reference Manual

Wand Emulation Interface 9 - 7

Convert All Bar Codes to Code 39

By default, the Wand Emulation Interface sends data to the attached host in the same symbology that was
decoded. This may present a problem for customers with older systems that do not recognize some newer
symbologies (for example, RSS).
Enabling this parameter ignores the original symbology that was decoded, and outputs the data as if it were a Code
39 bar code. Any lowercase characters that were in the original data stream are transmitted as uppercase
characters. This also allows ADF Formatting to occur.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding character in the Code
39 symbology set are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a corresponding character are
encountered, the scanner emits an error beep and no data is transmitted.
ADF Note: By default, the Wand Emulation Interface does not allow scanned data to be processed by ADF rules.
Enabling this parameter has the side effect of allowing the scanned data to be processed by the ADF rules
(Chapter 14, Advanced Data Formatting).
.
Convert to Code 39 for Wand Host
(Enable)
*
Do Not Convert to Code 39 for Wand Host
(Disable)