Host Parameters - Motorola Symbol LS3408 Product Reference Manual

6 - 4 Symbol LS3408 Product Reference Guide
RS-232 Host Parameters
Various RS-232 host types are set up with their own parameter default settings. Selecting the host type sets the
parameter defaults as listed in
Terminal Specific RS-232
Table 6-2
Parameter
Transmit Code
ID
Data Trans-
mission Format
Suffix
Baud Rate
Parity
Hardware
Handshaking
Software
Handshaking
Serial
Response
Time-out
Stop Bit Select
ASCII Format
Beep On <BEL> Disable
RTS Line State
Prefix
*In the Nixdorf Mode B or OPOS/JPOS, if CTS is Low, scanning is disabled. When CTS is High, the
user can scan bar codes.
**If Nixdorf Mode B or OPOS/JPOS is scanned without the scanner connected to the proper host, it
may appear unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of
cycling power to the scanner.
Table 6-2.
Standard Wincor-
RS-232 ICL Nixdorf
(Default) Mode A
No Yes Yes
Data as is Data/ Data/Suffix
Suffix
CR/LF CR CR (1013)
(7013) (1013)
9600 9600 9600
None Even Odd
None RTS/CTS RTS/CTS
Option 3 Option 3
None None None
2 Sec. 9.9 Sec. 30.0 Sec.
One One One
8-Bit 8-Bit 8-Bit
Disable Disable
Low High Low
None None None
Wincor-
Nixdorf Olivetti Omron
Mode B
Yes Yes Yes
Data/ Prefix/ Data/
Suffix Data/ Suffix
Suffix
CR (1013) ETX CR
(1002) (1013)
9600 9600 9600
Odd Even None
RTS/CTS None None
Option 3
None Ack/Nak None
30.0 Sec. 9.9 Sec. 9.9 Sec.
One One One
8-Bit 7-Bit 8-Bit
Disable Disable Disable
Low = No Low High
data to
send
None STX None
(1003)
OPOS/
Fujitsu
JPOS
Yes Yes
Data/ Data/
Suffix Suffix
CR CR
(1013) (1013)
9600 9600
Odd None
RTS/CT None
S
Option 3
None None
30.0 2 Sec.
Sec.
One One
8-Bit 8-Bit
Disable Disable
Low = Low
No data
to send
None None