Club Car 1995 Golf Car Maintenance Service Supplement page 25

NOTE
• FOR BEST RESULTS, THE CDM BODY SHOULD BE POSITIONED AT APPROXIMATELY 45° TO
GRADE (FIGURE 17-13). THE CDM MAY NOT PICK UP THE ON-BOARD COMPUTER DATA
STREAM IF CDM IS NOT POSITIONED PROPERLY WITH A CLEAR AND DIRECT PATH FROM
THE CDM LED TO THE ON-BOARD COMPUTER LED.
3. Wait approximately 30 seconds for a value to appear in the display window.
4. If a value does not appear in the display window after 30 seconds, try adjusting the aim of the CDM
slightly and repeating step 4 until a value appears.
Once a value has been obtained in the display window, the CDM may be removed from its receiving position
and the data reviewed. The CDM will hold the values for F1, F2, F3, and F4 until the CDM is turned off or it
receives another line of data from the same or another on-board computer. Use the following procedure to
review the data stored in the CDM:
1. The value currently displayed will be F1 (battery voltage).
2. To view F2, press and hold the button on the CDM. When "Func 2" appears in the display window,
release the button. The value for F2 will then be displayed.
3. To view F3, press and hold the button on the CDM until "Func 3" appears in the display window. Release
the button. The value for F3 will be displayed.
4. To view F4, press and hold the button on the CDM until "Func 4" appears in the display window. Release
the button. The value for F4 will be displayed.
NOTE
• THE VALUES OF ALL FOUR FUNCTIONS CAN BE RECALLED BY PRESSING AND RELEASING
THE CDM BUTTON.
Club Car
POSITION CDM SO THAT IT IS ALIGNED
DIRECTLY BEHIND THE ON-BOARD COMPUTER
FIGURE 17-12
BODY OF CDM SHOULD BE POSITIONED
AT APPROXIMATELY 45° TO GRADE
FIGURE 17-13
45°
17-23