Sharp MX-C380P Operation Manual page 250

Problem
The operation panel
cannot be used.
Printing is not
possible or stops
during a job.
The displayed bypass
tray paper size is not
correct.
Point to check
Does the message "Call for service.
Code:xx-xx*." appear in the display?
*Letters and numbers appear in xx-xx.
Is a tray out of paper?
Is the machine out of toner?
Has a paper misfeed occurred?
Is the output tray full?
Is the toner collection container full?
In the Paper Tray Settings of the system
settings, are restrictions placed on the
trays that can be used in print mode?
Is the bypass tray extension pulled out?
Make sure that the DATA indicator is not blinking or lit
and then switch off the [POWER] key (
main power switch.
Wait at least 10 seconds and then switch the main
power switch and the [POWER] key (
that order.
If the message still appears after switching the
[POWER] key (
several times, it is likely that a failure has occurred that
requires service. In this event, stop using the machine,
unplug the power plug, and contact your dealer or
nearest SHARP Service Department. (When contacting
your dealer or nearest authorised service
representative, inform them of the displayed error code.)
Add paper as instructed by the message in the display.
When toner runs low, a message will appear to inform
you that the toner cartridge must be replaced. To
replace the toner cartridge, see
TONER CARTRIDGES" (page 1-49) in "1. BEFORE
USING THE MACHINE".
Remove the misfeed as instructed by the message in
the display.
☞
REMOVING MISFEEDS
When the output tray becomes full, a detector activates
and stops printing.
Remove the output from the tray and resume printing.
Replace the toner collection container as instructed by
the message in the display.
☞
1. BEFORE USING THE MACHINE
THE TONER COLLECTION
1-52)
Check the Paper Tray Settings and see if checkmarks
appear in the checkboxes of print mode (Feeding
Approved Job). Functions without a checkmark cannot
be used for printing using that tray.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change" >
When loading paper in the bypass tray, be sure to pull
out the extension to enable the paper size to be
detected correctly.
4-17
TROUBLESHOOTING
Solution
) and the
) back on in
) and main power switch off and on
"REPLACING THE
(page 4-2)
"REPLACING
CONTAINER" (page