Generac Power Systems 13694330200 Owner's Manual page 26

Maintenance
Maint Maintenance
Maintenance Tasks
Task Completed
level
Interval
Date/lnitials
1. Disable the unit from operating per the first page warning.
2. Check the engine oil level. Adjust as necessary.
3. Check the engine coolant level. Adjust as necessary.
4. Check the engine coolant thermal protection level. Correct as neces-
sary.
5. Check the diesel fuel supply level. Adjust as necessary.
6. Drain water and sediment from the diesel fuel tank.
Every 12 months
or
7. Drain water from the diesel fuel line water separator if unit is equipped
100 hours of
with one.
operation
8. Check the air inlets and outlets for debris. Clean as necessary.
3
(Requires
9. Check the battery electrolyte level if accessible. Adjust as
approximately
necessary.
4,0 man hours
10. Check the battery posts, cables, and charger for loose connections,
per unit)
corrosion, and proper operation. Correct as necessary.
11. Check the unit wiring for loose connections, corrosion, and damage.
Correct as necessary.
12. Check the engine accessory drive belts for wear, weather cracking,
and damage. Replace as necessary.
13. Test the unit safety devices (alarms, shutdowns, etc.) for proper
operation. Correct and/or adjust as necessary.
14. Perform an oil analysis (send a sample to a lab for results). Change the
engine oil and filters if the analysis results indicate this is required.
15. Visually inspect the unit looking for leaks, wear or damage, loose
connections or components, and corrosion. Correct as necessary.
16. Start and exercise the unit under full rated load for at least 2 hours look-
ing for leaks, loose connections or components, and abnormal operating
conditions. Correct as necessary.
17.
Return the unit to standby setup for operation when required.
Technician's Signature Date Inspection Completed
Unit Hour Meter Reading at Completion of the Inspection
24