Maintenance; Cleaning - Zephyr ZPA-M90S Use, Care And Installation Manual

CLEANING

Surface Maintenance:
,
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or
abrasive detergent (e.g. comet powder scrub, EZ-Off oven cleaner), or steel wool/
scoring pads which will scratch and damage surface.
,
For heavier soil use liquid degreaser such as 'Formula 409' or 'Fantastic' brand cleaner.
,
After cleaning, you may use non abrasive stainless steel polish/ cleaners such as 3M or
ZEP, to polish and buff out the stainless luster and grain. Always scrub lightly, with
clean cotton cloth, and with the grain.
Metal Filters
,
The Metal Filters fitted by the factory are
intended to filter out residue and grease
from cooking. It need not be replaced on a
regular basis but are required to be kept
clean.
,
Filters should be cleaned after every 30
hours of use. Use the Filter Clean
Reminder function on the controls to
determine when filters require cleaning
(ref. page 8).
,
Remove and clean by hand or in
dishwasher. Spray 'Formula 409' or
equivalent degreasing detergent and leave
to soak if heavily soiled.
,
Dry filters and re-install before using hood.
Replacing Metal Filters
,
Should filters wear out due to age and
prolonged use, replace with following part
number:
Hood Model:
ZPA-M90S
,
Also replace damaged filter that has
punctured or broken mesh, bent or broken
frame.

MAINTENANCE

Part No. Filters in pkg.
Z0F-M032 2
9