Zephyr Essentials Tamburo ZTA-E30AS Use, Care And Installation Manual
Hide thumbs
Also See for Essentials Tamburo ZTA-E30AS:
- Use, care and installation manual (46 pages) ,
- Use, care and installation manual (44 pages) ,
- Use, care and installation manual (44 pages)
Subscribe to Our Youtube Channel
Related Manuals for Zephyr Essentials Tamburo ZTA-E30AS
Summary of Contents for Zephyr Essentials Tamburo ZTA-E30AS
- Page 1 Pyramid ZPY-E30AB, AW, AS ZPY-E36AB, AW, AS Tamburo ZTA-E30AS ZTA-E36AS Terazzo ZTE-E30AS ZTE-E36AS Model number: Serial Number: Date of Purchase: Sales Dealer: JAN11.0601 © Zephyr Corporation...
- Page 2 www.zephyronline.com...
- Page 3 SAFETY NOTICE ..............LIST OF MATERIALS ............INSTALLATION Ductwork Calculation Sheet ........Mounting Height & Clearance ........ Ducting Options ............Specifi cations ............... Preparing Electrical ............ Preparing Ducting Location ........Recirculating ..............Optional Utensil Bar ........... Mounting the Range Hood ........
- Page 4 www.zephyronline.com READ AND SAVE THESE INSTRUCTIONS WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE CONTROL DEVICE. WARNING TO REDUCE THE RISK OF FIRE ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a.
- Page 5 WARNING TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK. CAUTION To reduce risk of fi re and to properly exhaust air outside - Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages. Maximum weight of shelf space is 5 lbs.
- Page 6 www.zephyronline.com MODELS: ZPY-E30AB, AW, AS ZPY-E36AB, AW, AS ZTA-E30AS ZTA-E36AS ZTE-E30AS ZTE-E36AS PARTS SUPPLIED 1 - Hood 2 - Aluminum mesh fi lters (2) 2 - Halogen light bulbs (pre-installed) 1 - 7” round transition collar 1 - 3 1/4” x 10” rectangular collar with damper 1 - Utensil bar 1 - Hardware package HARDWARE PACKAGE CONTENTS...
- Page 7 Equivalent number Duct pieces Equivalent number Duct pieces length x used T otal T otal length x used 3- 1/ 4” x 10” 1 Ft. 6”- 8” Round 30 Ft. Rect., wall cap straight with damper 7” Round, 1 Ft. 6”- 8”...
- Page 8 www.zephyronline.com Minimum mounting height between range top to hood bottom should be no less than 24”. Maximum mounting height should be no higher than 32”. It is important to install the hood at the proper mounting height. Hoods mounted too low could result in heat damage and fi...
- Page 9 WARNING FIRE HAZARD NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside. Use metal ductwork only. Fasten all connections with sheet metal screws and tape all joints with certifi ed Silver Tape or Duct Tape. Some Ducting Options ductless recirculating...
- Page 10 www.zephyronline.com Note: Installation dimensions are the same for Pyramid, Tamburo and Terazzo 16 " 16 " 16 " 8 " " 2" 1" " 16 " 8 " 4 " elec. k/o 8" Pyramid 16 " 16 " 16 " 16 "...
- Page 11 ELECTRICAL WARNING All Electrical work must by performed by qualifi ed electrician or person with similar technical knowledge and background. For personal safety, remove house fuse or open circuit breaker before beginning installation. Do not use extension cord or adapter plug with this appliance. Follow national electrical codes or prevailing local codes and ordinances.
- Page 12 www.zephyronline.com Note: If using hood in recirculating mode skip these steps and turn to page 11. Vertical Ducting (7" Round) 1. Using a fl at-head screwdriver, remove both the 2. Secure 7" round collar to top of hood using rectangular and round knock-out plates located on (6) M4 x 8 screws.
- Page 13 Note: To use hood in air recirculating mode please purchase recirculating kit ZRC-0200 front slot metal air back slot diverter plate For Tamburo (ZTA) and Terazzo (ZTE) only: 1. Remove air diverter plate slot covers. Remove metal air diverter plate from front slot and re-position to back Unscrew and remove the front cover slot.
- Page 14 www.zephyronline.com Note: Utensil bar is designed for use when hood is installed under a 12" deep cabinet. There are 3 height options for installing the utensil bar. Install utensil bar and adjust the height before mounting the hood. Utensil bar should press against the wall when hood is installed. S-Hooks Fig 2 Fig 1...
- Page 15 Hood is designed for installation under a kitchen cabinet 8. Electrical 1. Select preferred duct location (vertical or horizontal) if ducting out of kitchen. Refer to page 10 for details. 6. Duct opening/ cutout 2. Install utensil bar to hood. Refer to page 12 for details.
- Page 16 www.zephyronline.com Blower On/Off Speed Selection Lights Off/Bright/Dim I I I BLOWER ON/OFF/SPEED SELECTION 0 is off, I is low speed, II is medium speed and III is high speed. LIGHTS OFF/BRIGHT/DIM 0 is off, I is bright, and II is dim.
- Page 17 SURFACE MAINTENANCE: Clean the hood surface periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent, or steel wool/scouring pads which will scratch and damage surface. Do not use products containing chlorine bleach or orange cleaners. For heavier soil use liquid degreaser.
- Page 18 If bulbs are diffi cult to turn due to prolonged use, fi rmly attach suction cup included in hardware package or use a rubber/latex glove and turn counter clockwise. Replacement bulbs are available at specialty lighting stores. Purchase type MR16 (GU-10) 50W halogen. For Zephyr part numbers please turn to page 18 of the manual.
- Page 19 TROUBLESHOOTING PROCEDURES FOR PYRAMID, TAMBURO AND TERAZZO Issue Cause What to do After installation, 1. The power source is not turned ON. 1. Make sure the circuit breaker and the unit’s the unit doesn’t power is ON. work. 2. The power line and the cable locking connector is 2.
- Page 20 www.zephyronline.com DESCRIPTION PART # Replacement Parts Light Bulb MR16 (GU10) 50W (each) Z0B-0020 Mesh Filter, All Models (each) 50200030 Optional Accessories Recirculating Kit, All Models ZRC-0200 Charcoal Filter Replacement (each) Z0F-C002 To order parts, visit us online at http://store.zephyronline.com or call us at 1.888.880.8368...
- Page 21 Zephyr Corporation (referred to herein as “we” or “us”) warrants to the original consumer purchaser (referred to herein as “you” or “your”) of Zephyr products (the “Products”) that such Products will be free from defects in materials or work- manship as follows: Three Year Limited Warranty for Parts: For three years from the date of your original purchase of the Products, we will provide, free of charge, Products or parts to replace those that failed due to manufacturing defects.
Need help?
Do you have a question about the Essentials Tamburo ZTA-E30AS and is the answer not in the manual?
Questions and answers