Troubleshooting - AEG DVD 4611 HC Operation Manual

Themen

Troubleshooting

Troubleshooting
Before sending the machine to the Customer Services, use the following table to check whether you can rectify the fault
yourself.
Fault Possible cause
The power supply light No power supply
does not light
no power supply/ mains switch
switched off
No image displayed on Video cable not correctly connected
screen
no DVD/CD inserted
DVD/CD not compatible
DVD/CD incorrectly placed in
CD/DVD-tray
CD/DVD is dirty
CD/DVD is damaged
Incorrect settings
The child lock system is activated
The wrong TV mode has been se-
lected (no P-SCAN-capable playback
device).
No response when Power supply problem or static
pressing button charging of appliance
No sound Audio cable not connected
Amplifi er switched off
Incorrect settings
The remote control does wrong direction
not work
too far away
Batteries empty
Titles are played in wrong Playlist is used
order
DVD cannot be played DVD has not been fi nalized
No radio reception. The antenna cable is not connected.
Poor radio reception. The received radio station is too
weak for a stereo operation.
In automatic search The transmission signals are too
mode the radio does weak.
not stop at a transmit-
ting station.
74
Solution
WARNING: Before troubleshooting, switch the player off.
Put the mains plug in correctly, if necessary, check the socket is
working with another appliance.
Switch the player on by the mains switch (Fig. 1/19).
WARNING: Before troubleshooting, switch the player off.
Check the correct fi t of the Video cable „Connecting the Video cable".
Make sure that the jacks are tightly in the sockets.
Insert a CD/DVD.
Use only compatible media (see „Technical data").
Turn the CD/DVD around.
Clean the CD/DVD around ➯ „Handling CD/DVD".
Use a different CD/DVD.
Check the settings of your DVD-Player.
Deactivate the child lock „Parental".
Press the V-Mode button (Fig. 3/29) to change the TV mode
(interlace).
Switch off the main switch and pull out the mains plug. Insert the
mains plug into the socket and switch the player on again.
WARNING: Before troubleshooting, switch the player off.
Video plug for transmission of the Video signal, you must use and
Audio cable in addition to the Video cable ➯ „Connecting the Audio
cable".
If you use an amplifi er for Audio output: check whether the amplifi er
is switched on.
Check the settings of your DVD-Player.
The remote control is not pointed towards the DVD-Player.
Make sure that the remote control is not further than
7 m away from the player.
Replace the batteries in the remote control ➯ „Remote control battery
installation".
Delete the playlist ➯ „Deleting a Playlist".
Use a fi nalized DVD.
Insert the antenna cable fi rmly into the antenna socket of the device.
Adjust the device to mono operation by pressing the MENU /
MO/ST button (fi g. 3/28).
Tune in to a radio station manually.