AEG DVD 4611 HC Operation Manual page 68

Table of Contents

Advertisement

Available languages

Available languages

Themen
Changing the default settings
68
NOTE:
If there is no Audio output, even though you connected the DVD-Player to an
amplifi er, you will most likely have chosen an incorrect setting for the Audio
output.
LPCM Output
NOTE:
The „LPCM Output" menu is only available if the „
activated in the „
Dialog Output
Here you can set the sampling rate of the audio signal. Generally speaking, a
higher sampling frequency produces a better audio signal.
Dolby Digital Setup
Dual Mono
The Audio output is normally in stereo. Here you have the possibility to choose
Mono-output instead of Stereo-output.
Stereo: The Audio output is in Stereo (default).
L-Mono: The Audio output is in Mono. In this case the signal of the „left"
stereo channel is transmitted to all speakers.
R-Mono: The Audio output is in Mono. In this case the signal of the „right"
stereo channel is transmitted to all speakers.
Mix Mono: The Audio output is in Mono. In this case the signal of the
„both" stereo channel is transmitted to all speakers.
Dynamic
The term „Dynamic" (Dynamic Range) describes the ratio of quietest and
loudest sound. If the dynamic range is very large, you will experience very
quiet and very loud sounds.
This may cause replay problems. Let us assume that you are watching a DVD
in a relatively loud environment. You can now increase the volume to be able
to hear also the very quiet passages, however with the disadvantage that
loud passages will be unacceptably loud. In this case it would make sense to
compress the dynamic range (i.e. reduce) and increase the output volume at
the same time.
FULL -3/4: The dynamic range is compressed slightly (3/4) to full (FULL).
OFF: The dynamic range is not compressed at all (default).
Channel Delay
If you use a 5.1-Audio system, you may experience a distortion of the sound
impression caused by the distance differences between speaker groups and
listener. Sounds that should be heard by the listener at the same time arrive
successively.
Here you can delay the sound produced by the central and rear loudspeakers
or subwoofer in order to produce a more balanced sound for the listener.
PCM only
" menu.
" option is

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents