Reinstalling The Motherboard - HP Omnibook XE3 Service Manual

Reinstalling the Motherboard

Reassembly Procedure
1. Install the CPU support plate.
2. Insert the I/O connectors through their openings in the bottom case, then lower the motherboard
into place.
•
Be careful not to trap the modem or modem/LAN cable(s) or headphone PCA cable under the
motherboard (modem and modem/LAN models only).
•
Fit the modem cable through the notch on the edge of the motherboard, and make sure the
LAN cable doesn't block the nearby screw tab.
•
Make sure the alignment posts in the bottom case fit through the holes at the back left and
front right corners of the motherboard.
3. Reconnect the cable (modem models only) or cables (modem/LAN models only) at the right rear
corner of the motherboard.
4. Reconnect the headphone PCA cable.
When Installing a New Motherboard
After installing a new motherboard, you must electronically transfer to it the serial number and service
ID from the previous motherboard, and set the video DIP switches for the notebook's display type.
1. Exit Windows and boot to a DOS prompt:
•
For Windows 98 or ME, press F8 during reboot and select Command Prompt Only.
•
For Windows 2000 or XP, boot from a DOS boot floppy disk.
2. Run ESN.EXE from the same source you ran it from when saving the serial number and service ID
from the previous motherboard:
•
On a factory software installation, change to the \hp\drivers\hputils directory and type
the prompt.
– or –
•
Copy \hp\drivers\hputils\ESN.EXE from the Recovery CDs, then run it on the notebook.
3. Install the serial number and service ID.
•
If you are prompted for the serial number, type the serial number shown on the bottom of the
case.
•
If a serial number has already been stored, you must call an HP support center to change it.
4. Set the DIP switches on the motherboard to match the settings for the notebook's display type. See
Table 2-8 on page 2-18.
HP Omnibook XE3 (Technology Code GF) Removal and Replacement
at
esn
2-35