Powering Your Blu-Ray Player - Audiovox AVDBR1 Owner's Manual

Installation
HDMI CONNECTOR

Powering Your Blu-ray Player

1. Connect the long black wire (-) to the
vehicle ground.
2. Connect the long red wire (+) to a
switched (Accessory) 12 VDC source.
3. Connect the 4-pin power connector to
the POWER connector on back of the
player.
Notes
• When connecting power and ground
in a mobile video installation ensure
that the ACC wire is fused at the point
where it is connected to the vehicle
ACC wiring. Failure to do so can result
in damage to the vehicle if a short
circuit develops between the vehicle
connection point and the mobile video
product.
AUDIO & VIDEO
OUPUT RCA JACK
3 PLACES
Rear Panel
- 9 -
12 VDC INPUT
4 PIN POWER
IR SENSOR
CONNECTOR
INPUT JACK
Red (+) to
Black (-) to
switched
ground
12 VDC
Fuse
housing
with 5A
fuse