Table of Contents
Advertisement
Installation
Before installing the player:
• Choose a mounting location where the
Blu-ray player does not get in the driver's
way and cannot injure the passenger in
the event of an emergency stop.
• Connect the wiring temporarily. Make
sure the Blu-ray player is connected
correctly and the Blu-ray player and the
system work properly.
Installing the Player
1. Install the Blu-ray player in a horizontal
position with the front end up at a
convenient angle, but not more than 30
degrees.
2. Screws are provided to attach the Blu-
ray player to the (two) L-brackets. Fasten
the unit to the L-brackets by aligning
the screw holes on the L-brackets with
the screw holes on the unit. Refer to the
following figure.
3. Tighten the screws on each side of the
Blu-ray player.
4. Use self-tapping screws (not supplied)
to mount the L-brackets in the vehicle.
Be careful of hidden wiring under the
carpet.
Notes
• To ensure proper installation, use only
the parts included with the Blu-ray
player. The use of unauthorized parts
can cause malfunctions.
• Avoid installing the Blu-ray player
where it would be subject to high
temperatures, such as from direct
sunlight or from hot air from the
vehicle's heater. Also avoid locations
where the player would be subjected to
dust, dirt or excessive vibration.
- 8 -
Advertisement
Table of Contents
