FLIR D-Series Installation Manual page 22

2—Verify Camera Operation
After a brief while, the FSM main window will appear. A popup FSM Notification
window will appear in the lower right of the screen indicating that no cameras
(servers) have been discovered yet.
Step 2 Click on the Accept button to acknowledge the
notification.
The FLIR Sensors Manager uses a "client/
server" architecture. The FSM software is
considered a client, and the cameras are
considered servers or sensors.
The Sensors Panel in the upper left of the window indicates no sensors have been
discovered and added to the list of Active Sensors.
Step 3 Click on Setup, if required, then the Discovery button on the side panel to bring up
the Discovery Panel. The FSM software can automatically discover FLIR cameras on
the network.
Step 4 When the Discovery Panel is displayed, click Refresh.
The FLIR camera will appear in the list of Discovered Servers. The camera will be
called "flir", and the asterisk in parenthesis "(*)" indicates the camera has not been
added to the list of Active Servers on the right.
Step 5 Click on the center bar ">" to move the camera over to the list of Active Servers.
By default, the FSM software will automatically discover sensors in the network,
connect to the first camera it finds, take control of the camera, and display the video
from the camera in Video Wall 0.
No Sensors Discovered
Zoom/Pan/Tilt
Camera Controls
2-4
3. Refresh 4. Move to Active
January 2012
D-Series Installation Manual
1. Setup 2. Discovery
427-9029-00-12, version 120