Download Table of Contents Print this page

System; Rinse Aid; Setting Amount Of Rinse Aid - Siemens SN55M531TI Operating Instructions Manual



Table of Contents

Rinse aid

Switching off salt refill
indicator/water softening


Sw i t c h i n g of f w a t e r so f t e n i n g s y s t e m
If the salt refill indicator @ is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
Proceed as described under
"Adjusting the water softening
system" and set the value to :
The water softening system and salt
refill indicator are now switched off.
Never fill the salt dispenser with
detergent. You will destroy the water
softening system.
Rinse aid
a i d
R i n s e
As soon as the rinse-aid refill
indicator H is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 9" by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.

Setting amount of rinse aid

The amount of rinse aid can be set from
to :
to obtain very good drying results
( :
is already set in factory).
Change this setting, only if streaks
(select lower setting) or water stains
(select higher setting) are left on the
1. Close the door.
2. Switch on ON/OFF switch (.
. Please set rinse aid on


Table of Contents

This manual is also suitable for:


Table of Contents