Table of Contents
Advertisement
Installation and Setup
Connecting the Wireless Base Unit
Place the Wireless Base Unit close to the Ethernet outlet you want to use for the conference phone. Connect the Wireless
Base Unit to the network using the provided Ethernet cable.
The Wireless Base Unit is powered using Power over Ethernet (PoE).
Connecting the Charger Tray
Place the Charger Tray at a location where you can easily access the Microphones and the Speaker for your conference
calls (e.g. on a side board, a desk, or the conference table).
Connect the Charger Tray to a power outlet using the provided 12-15V power supply.
Place the Speaker, the Microphones, and the Handset/Dialer in the respective openings of the Charger Tray to charge
them.
The Handset/Dialer and Speaker will automatically connect to the Wireless Base Unit after a short time when powered up.
You will hear a confirmation chime from the Speaker once the system is ready for use. The Microphones only connect
when taken out of the Charger Tray, or if the multi-function button is pressed while in the Charger Tray. If the Speaker or
the Handset/Dialer are not powered up, take them out of the Charger Tray for a few seconds and put them back in. This
will switch on the component.
2
41-001515-00 REV00 – 06.2013
Advertisement
Table of Contents
