Table of Contents
Advertisement
Installation
Important
Failure to allow adequate ventilation to the appliance may result in
overheating or damage to adjacent units and could invalidate the
warranty. The diagram below shows the minimum required.
This appliance is type X installation. The walls of the kitchen units must
be able to withstand temperatures of 75 ° C above ambient (typically this
is between 90 ° C and 100 ° C).
When correctly installed ensure that there is a gap of 4mm minimum
between the sides of the oven and adjacent furniture doors.
Lift the oven carefully into position on the shelf, taking care NOT to lift
it by the door handles. If you lower the oven door, you will see 4 screw
holes, 2 on each side of the oven. The oven should then be secured to
the housing by fitting screws into these holes. Remember the housing
should not be free standing but be secured to the wall and/or adjacent
fittings.
How to install your oven
You will need the following housing area fit your oven correctly.
DC740 only: We recommend that you fit end support panels onto the
adjacent units to allow the oven to be secured in place (as shown in
fig. 10).
19
Hide quick links:
Advertisement
Table of Contents
